Metal Mirror Hanging
I found this mirror on the curb and was looking to hang it up, on a concrete wall I have, but I'm noticing that the back seems to only have some rings for support (each square, about 1 inch in width - you can see one on the top left, two on the bottom left, and one on the bottom right. They're not evenly dispersed across the border). Does anyone have any recommendations for what to use to hang it up? I was initially just going to go with some concrete screws / anchors, but I'm not sure if having them hang out by ~1/2" so that they can extend far enough from the wall to fit through the rings would be enough support. The mirror is entirely metal, and weighs about 8 kg total. submitted by /u/CdrGermanShepard [link] [comments]
I found this mirror on the curb and was looking to hang it up, on a concrete wall I have, but I'm noticing that the back seems to only have some rings for support (each square, about 1 inch in width - you can see one on the top left, two on the bottom left, and one on the bottom right. They're not evenly dispersed across the border).
Does anyone have any recommendations for what to use to hang it up? I was initially just going to go with some concrete screws / anchors, but I'm not sure if having them hang out by ~1/2" so that they can extend far enough from the wall to fit through the rings would be enough support.
The mirror is entirely metal, and weighs about 8 kg total.
[link] [comments]
