Bad join on existing crown moulding

I am going to repair this but I am not sure which way to go. The moulding on the left is proud about 1/8” from the other. I could pull both away at these ends and shim the piece on the left. Any other bright ideas? submitted by /u/fartman2020 [link] [comments]

Mar 15, 2025 - 23:05
 0
Bad join on existing crown moulding
Bad join on existing crown moulding

I am going to repair this but I am not sure which way to go. The moulding on the left is proud about 1/8” from the other. I could pull both away at these ends and shim the piece on the left. Any other bright ideas?

submitted by /u/fartman2020
[link] [comments]