.jpg)
Flex of Tub Lip
https://imgur.com/a/hmji5sW I considered raising the frame with spacers to get rid of the lip flex, but then worry about putting too much pressure on the lip that could eventually lead to failure of the tub. What's the right way to fix this? The tub is embedded in thinset so it's not going anywhere. submitted by /u/No_Spin_Zone360 [link] [comments]
I considered raising the frame with spacers to get rid of the lip flex, but then worry about putting too much pressure on the lip that could eventually lead to failure of the tub. What's the right way to fix this? The tub is embedded in thinset so it's not going anywhere.
[link] [comments]
