Plumbing question
I built my own house 9 years ago. I used professional trades for plumbing, electrical, and HVAC. I recently noticed that water pressure on the house side of the PRV was higher than it should be. The PRV is set to 50 psi but the pressure would creep up to around 100 psi if water was not being used much. If I opened a tap it would drop back down to 50 psi. So I replaced the PRV but a few days later I am noticing the exact same behaviour. Does anyone have any ideas as to what is happening and what I can do about it? submitted by /u/Charlie9261 [link] [comments]
I built my own house 9 years ago. I used professional trades for plumbing, electrical, and HVAC. I recently noticed that water pressure on the house side of the PRV was higher than it should be. The PRV is set to 50 psi but the pressure would creep up to around 100 psi if water was not being used much. If I opened a tap it would drop back down to 50 psi. So I replaced the PRV but a few days later I am noticing the exact same behaviour. Does anyone have any ideas as to what is happening and what I can do about it?
[link] [comments]
